LD-100 Heated Diode Refrigerant Leak Detector

Elitech LD-100 heated diode refrigerant leak detector offers great sensitivity (3g/yr) and short response time (<3s). It will respond to all halogenated (including Chlorine of Fluorine) refrigerants. This is achieved through the employment of a high sensitive heated diode sensor combined with a sophisticated microprocessor-controlled circuit. In addition to the supreme performance and functional advantages, it is economic and user friendly.

Maintenance
Proper maintenance is important and may extend the service life and improve the performance of your detector.
Warning: Turn the power off before cleaning the body of the device.
Keep the sensor tip clean: Use a cotton cloth or dry air to clean the shield on the sensor tip if it gets contaminated. If the sensor tip itself is contaminated, soak the tip in absolute alcohol for a few minutes, and then use compressed air to dry it, or dry it with a cloth.
Note: Never use strong solvents such as Gasoline, mineral oil, turpentine, these solvents may coat the sensor with a thin film and reduce the sensitivity of the detector and make the detector slow in respond to a leakage.
Put the detector and the sensor in a dry and clean place and remove the batteries if the detector is not used for a long time.